Products - Control Panels

Installation, wiring and troubleshooting information about the Group SCS range of control panels.

• Do I need to provide access to the panels for maintenance?
• I have 230V smoke detectors installed. Can I use these to trigger the EV-301/EV-601?
• How many cores do I need to install between the panel and the fireman’s switch?
• How do I interconnect control panels?
• Is it possible to set a service timer?
• EV-301+ EV-601 Instruction Manual
• How many actuators can be run from 1 Ev-301/EV-601 control panel?
• Can you replace a SP-300 panel with an EV-301 panel?
• How many smoke detectors can I connect to a single EV-301/EV-601 panel?
• Can I use EV-301/EV-601 for DV functions?
• If my EV-601/EV-301 Control Panel is in 'fault', how do I understand the fault?
• How do I know if my EV-601/EV-301 Control Panel is in ‘fault’?
• How do I connect a fire alarm interface to an EV-301 / EV-601?
• I have replaced the batteries and it’s still showing a battery/power fault?
• Do the panels offer open & close vent delay?
• How do I wire a Wind/Rain sensor to an EV-301/EV-601 Control Panel?
• Can the switch input work as a dead-man function?
• Do the panels offer gap ventilation?
• Do the panels have a timed ventilation setting?
• Can I use the EV-301/EV-601 control panels for daily ventilation?
• How do I know if my panel is in EV or SP mode?
• Do I need a switch at the top and the bottom of the stairs?
• Where do I connect sprinkler system to EV-301?
• Do you have just DV panels?
• Can I install the EV-301/EV-601 panel in the smoke shaft?
• Do I have to connect the system to a fire alarm system?
• What is the difference between the EV and SP mode on the EV 301/601 control panels?
• Where can I buy HE075/HE076 switches from?
• Where can I buy spare parts for the W1 (W1/1001) system from?
• What is the best solution for replacing a SP-200 system?
• What can I replace a SP-300 control panel with?
• Do I need to buy a switch?